1569352488 Publish time 2019-9-25 03:18:40

adeept rasparm keeps falling off

Hi, I'm buliding the adept rasparm. However, i find the arm keeps detaching from the base. On page 49 of the assembly tutorial it shows an the "M3*4 screw from servo" but I wasn't able to thread it. Am I doing something wrong?

1578942552 Publish time 2020-1-28 05:33:37

i think it will only thread into sg-5010 servo. are you trying to thread into the mg946-r ?

i found it hard the thread the claw servo aswell.

Adeept Publish time 2021-2-4 17:13:49

Please send us a detailed description of the problem you encountered by email (including which product you bought, description of the problem, and picture provided): support@adeept.com

Adeept Publish time 2021-2-4 17:14:02

1578942552 replied at 2020-1-28 05:33 AM
i think it will only thread into sg-5010 servo. are you trying to thread into the mg946-r ?

i found ...

Please send us a detailed description of the problem you encountered by email (including which product you bought, description of the problem, and picture provided): support@adeept.com
Pages: [1]
View full version: adeept rasparm keeps falling off