- 4WD Smart Car remote control problem
Hello !! After assembly and firmware flash car moving right when i turn joystick left and moving left when i turn joystick right please help!!Refer to this blog.It describes how to control the steering of the car: https://www.adeept.com/blog/tutorials/how-to-use-the-remote-control-to-control-the-movement-of-the -car.html This blog describes how to control the operation of the car: https://www.adeept.com/blog/tutorials/experiment-of-controlling-the-moving-direction-and-the-speed-of-the-4 -wheel-smart-car.htmlThank you. Edited by 1536583925 at 2020-10-7 07:03 PM
Dear Sirs, I have problems in the operation of your "Adeept Remote Control Smart Car Kit for Arduino based on NRF24L01 2.4G". The car, controlled by its remote control, when it has to turn right goes left and vice versa. I have read in the blog and in the forum several suggestions and code examples but they have further confused my ideas. Is it possible to have the complete code of the two programs "AdeeptRemoteControl.ino" and "AdeeptMotor.ino" in the definitive and bug-free version? Thanks for your kind response.
Giuseppe Mannino
P.S.I load the new program in https://www.adeept.com/learn/detail-4.html (reverse direction) and now the car turns ok, but the radar (mode2) is not functioning. There are some modifications to do in the new code (which is dependent on the modification made to steer correctly)? The car, in front of an obstacle, continues to move forward.
1536583925 replied at 2020-10-4 06:06 PM
Dear Sirs, I have problems in the operation of your "Adeept Remote Control Smart Car Kit for Arduino ...
First test whether the ultrasonic data can be read normally, and then fine-tune the code according to whether he can turn. The direction of the turn should not be considered. There may be an error in the ultrasonic reading data.
Pages:
[1]