1706550070 Publish time 2024-1-30 01:58:59

Adeept Robot HAT 2.0 motor encoders connection

Hi everyone!

I'm thinking to replace existing morots by motors with encoders for AWD car.

The question is that I need to connect somehow encoders to Raspberry PI (4B) via HAT, to do that I need 4 pins - 2 for power (3.3 or 5v) and 2 for data (AB-phase encoder) for each motor (most likely I can parallel power for both encoders, but for data I need 4 GPIO ports).

Based on https://www.adeept.com/video/static1/itemsfile/Circuit%20Schematic.pdf I'm thinking to use Tracking (or MPU6050 or UART) and IIC headers for connection but I have no idea which type of connectors to buy.

Probably someone knows what should I choose?

Adeept_Devin Publish time 2024-2-6 15:37:41

If you use the IIC interface, you need to use the corresponding "XH2.54mm" terminal.
If you use MPU6050, you need to use "2.54mm" pin header.
It is recommended to use 2.54mm pin headers to weld at 40 circular holes. The 40 circular holes correspond to the 40 Pins of the Raspberry Pi.

1706550070 Publish time 2024-2-8 02:05:33

Adeept_Devin replied at 2024-2-6 03:37 PM
If you use the IIC interface, you need to use the corresponding "XH2.54mm" terminal.
If you use MPU6 ...

Many thanks for your advice! Just have ordered 2p20 pin header!
Pages: [1]
View full version: Adeept Robot HAT 2.0 motor encoders connection