View: 1053|Reply: 1

Left motor wire routing on AWR?

[Copy link]

1

Threads

1

Posts

9

Credits

Newbie

Rank: 1

Credits
9
Post time 2020-6-5 10:45:16 | Show all posts |Read mode
I'm assembling my AWR and have run into a problem. The wire for the connector for the left-side motors (the ones on the acrylic that the Pi and hat are attached to) doesn't seem to be long enough to reach the motor-B port on the hat. I have the connector wire coming off of the vertically-oriented motor and coming over the top of the hat by the PWM pins, but that doesn't seem to be where the wire is coming from in the video, although I can't make out the detail.

Can someone post a picture or instructions about how the connector wire for the left-side motors is supposed to be routed so it can reach the motor-B port on the hat?

Thanks very much for any help you can offer!


Reply

Use magic Report

1

Threads

49

Posts

150

Credits

Registered member

Rank: 2

Credits
150
Post time 2020-7-20 16:44:48 | Show all posts
There are some vacancies on the panel for screwing screws with a relatively deep groove, which is used for wiring.The length of the line is sufficient, because we have verified it many times.You can view the awr assembly video on youtube. Thank you.
Reply

Use magic Report

You have to log in before you can reply Login | Sign Up

Points Rules