|
|
Edited by 1590741547 at 2021-3-15 10:42 PM
i know my servos are pluged into the the correct GIOP pins but something is screwed up;
take a look at the following diagram,
so...after much trial and tribulation i finally got my tank to link to my computer and run.
the problem i have is the arm controls. the up/down buttons control the camer/sensor servo.
there is no control for the lower arm servo. the jaws, wrist, and upper arm work just fine. the motor controls also work just fine.
any help you can give me would be greatly appriciated.
Jim
Sorry, don't know why 2 images are showing up.
OPPS, posted this in the wrong form, should be in raspberry pi/robots form, maybe someone can move it over.
After doing more research, i have discovered that the servos are all working properly, so ingnore my initial post.
|
|
Post time 2021-3-14 23:14:03
