View: 1440|Reply: 5

Robotic Arm Kit for Arduino - how to reset?

[Copy link]

1

Threads

1

Posts

5

Credits

Newbie

Rank: 1

Credits
5
Post time 2022-12-27 07:05:08 | Show all posts |Read mode
Dear all,
as I'm a beginner, a very basic question: what can I do to reset the board to the very initial setup so the manual control of the arm via the board is working again?

After starting the first lessons, I received some errors.

Thanks a lot!!!
Reply

Use magic Report

0

Threads

1

Posts

4

Credits

Newbie

Rank: 1

Credits
4
Post time 2023-1-20 16:26:12 | Show all posts
Any updates on this? my board is in an endless cycle and can't upload anything
Reply

Use magic Report

0

Threads

1

Posts

4

Credits

Newbie

Rank: 1

Credits
4
Post time 2023-4-3 18:21:56 | Show all posts
This site may be a walk-through like the knowledge you wanted concerning this and didn’t know who ought to. Glimpse here, and you’ll absolutely discover it.        rental car in karachi
Reply

Use magic Report

0

Threads

4

Posts

10

Credits

Newbie

Rank: 1

Credits
10
Post time 2024-2-3 17:31:06 | Show all posts
Edited by 1706952001 at 2024-2-3 05:33 PM

Physically disconnect the Arduino from the power source or USB cable and reconnect it. This action is equivalent to a power cycle and will restart the board.
Reply

Use magic Report

0

Threads

1

Posts

6

Credits

Newbie

Rank: 1

Credits
6
Post time 2024-5-6 04:05:12 | Show all posts
1706952001 replied at 2024-2-3 05:31 PM
Physically disconnect the Arduino from the power source or USB cable and reconnect it. This action i ...

I disconnected the USB cable from my PC.  Then turned off and on and off again the board's power switch.  When I turned it back On again, with the USB disconnected; I still don't have any action from the Pots, even the Display does not show anything.  I'm trying to get it so the pots work again.  I even tried the Unpacking_Test_Code.ino program; but this gives me this error:  #include  <Adafruit_I2CDevice.h>
          ^~~~~~~~~~~~~~~~~~~~~~
compilation terminated.
exit status 1


Reply

Use magic Report

0

Threads

53

Posts

201

Credits

Administrator

Rank: 9Rank: 9Rank: 9

Credits
201
Post time 2024-5-17 15:22:44 | Show all posts
1714938966 replied at 2024-5-6 04:05 AM
I disconnected the USB cable from my PC.  Then turned off and on and off again the board's power s ...

If the computer cannot recognize the COMx port, it may be because the computer has not successfully installed the CH340 driver.

If an error message related to "Adafruit_I2CDevice.h" appears, it may be caused by the failure to successfully import the corresponding dependent library. Please import the dependent library into the Arduino IDE according to the tutorial "_4 Building the Arduino Development Environment" file.

Reply

Use magic Report

You have to log in before you can reply Login | Sign Up

Points Rules