USD
EUR
GBP
CAD
AUD
JPY
KRW
Your position: Home > All Products
- Description
Features:
2.8V Regulator - Provides the required 2.8V for the sensor
I2C Level Shifter - Provides logic level conversion from 2.8V to VCC
3-in-1 Module
IR Emitter
Range Sensor
Ambient Light Sensor
Measures absolute range up to 10cm
Gesture Recognition
I2C Interface
Two Programmable GPIO
Sharp Sensor Board Layout
Pinout Description:
VIN This is the main 2.7 V to 5.5 V power supply connection. The SCL and SDA level shifters pull the I⊃2;C lines high to this level.
GND The ground (0 V) connection for your power supply. Your I⊃2;C control source must also share a common ground with this board.
SDA/SDI/SDO Level-shifted I⊃2;C data line: HIGH is VIN, LOW is 0 V
SCL/SPC Level-shifted I⊃2;C clock line: HIGH is VIN, LOW is 0 V
GPIO0/CE This pin is configured as a chip enable input on power-up of the VL6180X; the board pulls it up to VDD to enable the sensor by default. Driving this pin low puts the sensor into hardware standby. After the VL6180X powers up, this pin can be reconfigured as a programmable interrupt output (VDD logic level). This input/output is not level-shifted.
GPIO1 Programmable interrupt output (VDD logic level). The VL6180X also drives this pin low when it is in hardware standby. This output is not level-shifted.
2.8V Regulator - Provides the required 2.8V for the sensor
I2C Level Shifter - Provides logic level conversion from 2.8V to VCC
3-in-1 Module
IR Emitter
Range Sensor
Ambient Light Sensor
Measures absolute range up to 10cm
Gesture Recognition
I2C Interface
Two Programmable GPIO
Sharp Sensor Board Layout
Pinout Description:
VIN This is the main 2.7 V to 5.5 V power supply connection. The SCL and SDA level shifters pull the I⊃2;C lines high to this level.
GND The ground (0 V) connection for your power supply. Your I⊃2;C control source must also share a common ground with this board.
SDA/SDI/SDO Level-shifted I⊃2;C data line: HIGH is VIN, LOW is 0 V
SCL/SPC Level-shifted I⊃2;C clock line: HIGH is VIN, LOW is 0 V
GPIO0/CE This pin is configured as a chip enable input on power-up of the VL6180X; the board pulls it up to VDD to enable the sensor by default. Driving this pin low puts the sensor into hardware standby. After the VL6180X powers up, this pin can be reconfigured as a programmable interrupt output (VDD logic level). This input/output is not level-shifted.
GPIO1 Programmable interrupt output (VDD logic level). The VL6180X also drives this pin low when it is in hardware standby. This output is not level-shifted.
You May Like
-
$123.49
-
$189.99
-
$114.99
-
$99.99
-
$79.99
-
$169.99
-
$89.99
-
$44.99
-
$37.49
